The detector offers 4 user interface
levels for this section to accomodate any
application requirements.
1
Connect the main cable from the detector
to the proper power outlet.
2
Depress the main switch to position “I”. On
the control panel, the indicator lights flash.
3
The following screens are shown on the
LCD.
4
When the detection
pump reaches its
nominal speed, the
unit autocalibrates
itself.
5
When calibration is
completed, the unit is
ready to start a cycle.
STDBY
STDBY
STDBY
STDBY
TEST
TEST
TEST
TEST
F1
F3
F2
F4
PLEASE WAIT…
adixen ASM...
UNIT : mbar.l/s
SOFT : Lxx Vx.x rxx
F1
F3
F2
F4
PLEASE WAIT…
DETECTION PUMP: 75%
F1
F3
F2
F4
AUTOCAL IN PROGRESS
ELECTR. ZERO ADJUST.
80
F1
F3
F2
F4
READY FOR CYCLE
INLET VENT : off
To know your user interface level and to change it
C 120
5
Start-up
ASM 142/GRAPH
After unpacking the unit, please fill up the roughing pump with
oil, as indicated in the Operating manual .
E 750
CAUTION
User interface level
1
2
3
4
Setting and maintenance part
User part
LEVEL
This level has very limited information on the alphanumeric display (LCD). This level is
generally selected for production types of applications.
No access to control keys (Cycle
key included).
LEVEL
This level allows the operator to visualize some parameters without the possibility of
making any changes.
Same as Level
1
, this level is usually selected for production types of applications.
Access to all the control keys.
LEVEL
Same as level
2
but with possibility to set some parameters. This level is generally
selected for maintenance applications.
LEVEL
This level allows access to all the parameters and is generally used for settings all
the parameters.
Note: When switching from levelL
4
to any other level, the switch can be performed
without using the password. This level is generally selected for R&D applications.
