User manual MKA 120
Conforms to
Issue 07.07.2021_01 Page 24
Inserting a step
Inserting the previously selected step.
Confirm your entry by pressing Enter
(box )
or cancel by
pressing Cancel
(box ).
7.6 Program end
At the end of a program the controller will change from operating mode
into „Program end“ mode. The
„Start/Stop“ LED will be flashing.
During this time you can skip between nominal values. This allows you to display e.g. the F-value after
the end of the program.
Press the „Start/Stop“ button to change into standby mode.
8
Operating mode display and settings
The controller is in operation, this means a program is running.
The LED in the
„Start/Stop“ button is lit. On the info bar the states of the relays are shown
1
.
8.1 Nominal values
A service technician can make nominal values available by changing the configuration of the
controller.. The relevance of these nominal values can vary, this is why your service technician
should explain them to you.
1
Depends on whether the setting has been enabled under Item 9.2 Status.
Be aware
When you press the
„Enter“ button the step will be
automatically copied.
A step which already exists in this position will be overwritten!
Deleting or inserting steps can lead to an unintentional linking
of programs or the breaking up of a previous program link!
1
2
1
2
Figure 10: Operating mode
Actual value Temp/
Shotcut buttons
Status bar
(e.g. Relay states)
Actual value
core temperature/
Shotcut buttons
Actual value
Step time /
Operating time
Nominal value (Temp, FC-value,...)
Nominal value (Core, FC-value,...)
Nom. value Time
Unit (°C / °F)
Unit (°C / °F)
