Temperature Controller ETA 110
_________________________________________________________________________________________________________
_________________________________________________________________________________
04.06.09 page 1
ETA110 V03
Operating manual
04.06.09
The
ETA 110
works as a
heating-
or
cooling controller
. A second relay can be used as either
an operating, alarm,
upper limit
or
lower limit relay
.
The
heating control
can work in either
two point
-,
XP
or
interval operation
.
The nominal value limit for the temperature can be set by using a code.
When the controller is switched on while the buttons „Plus“ and „Minus“ are pressed
simultaneously, the nominal temperature value is
reset to „0“.
The actual temperature is shown in the upper display and the nominal temperature in the lower
display.
As soon as the controller has been connected to the mains it is in operating mode. (Please note:
also see “setting options” under code „100“).
The nominal temperature can be set within the programmed limits by using the „Plus“- and
„Minus“ buttons.
Code entry
: press the two buttons on the outer left and right simultaneously, for ca. 3
seconds. The lower display will show „Cod“. Use the „Plus“ and „Minus“ buttons to set the code
numbers (upper display). Confirm the code by pressing the same outer buttons again. To quit
the code, press these two buttons yet again.
Activation or deactivation of the outer left button: Code 100
Upper displa
y shows „StP“.
Choose between „OFF“ (deactivated) and „On“ (activated) by using the arrow
buttons.
Be aware: the following only applies when the button on the outer left has been
activated:
Display
–actual
temperature
Display -nominal
temperature
button outer
left
button
outer right
arrow
buttons
plus/minus
1
2
