29
Adirondack Spas
®
OWNER'S MANUAL
continuous Filtration non-circulation pump
To set a continuous filtration, set Filter 1 to begin at a specified time as listed above . Because
you will be running the Pump 1 low speed continuously, any start time will be fine, as the start
and end time will be the same . Remember that your cost of operation will increase by operating
Pump 1 on low speed as continuous filtration .
{Example: Start time: 8am - End time: 8am = 24-Hour Circulation}
Then set the duration as listed above, advancing the duration hours to 24 . The FLTR2 cycle start
time, 12 hours after the FLTR1 start time will only engage the Purge Cycle . The end time for
FLTR2 in this setting will be unavailable with 24-Hour duration .
* When Pump 1 low is operating and an ozone generator is installed, they will operate together .
*Default factory setting is one filter cycle set to run in the evening (assuming the time of day is
properly set). The second filter cycle can be enabled as needed.
*At the start of each filter cycle Pump 2 (if one is present) will run briefly to purge its plumbing
to maintain water quality .
