ADIC Tape Array 5, Руководство пользователя

Страница: 26 / 46

16
Operation and Maintenance
Powering on the System
1. Plug the power cord into the back of your T5 Enclosure.
2.
Plug the power cord from the T5 Enclosure into a grounded electrical outlet.
Use caution when plugging the power cord into an electrical outlet.
Hazardous voltages are present in the sockets of the outlet.
3.
Plug the power cord from your host computer into a grounded electrical outlet.
Turn on the power switch located on the rear panel of the T5 Enclosure. Turn on the host computer power.
When the drives have completed their boot and initialization processes they are On-line on the appropriate
SCSI bus(ses).
Normal Operations
General Guidelines
Once your T5 Enclosure and your choice of application software are installed and configured, you can
automatically perform backup and restore operations via the application software. You do not need to
intervene unless the application software instructs you to exchange data cartridges.
Always follow these general-operating guidelines:
p
Use only the recommended types of media cartridges described in this manual.
p
Clean each of the DLT drives once a month, or whenever the Use Cleaning Tape LED is illuminated
on a drive front panel.
Drive(s) Power-on Self-Test
When you power up your T5 Enclosure, the DLT drives each perform a Power-on Self-Test (POST) while
the library is performing the Power-Up Checks. The sequence of events for each drive is:
1.
The LEDs on the right front panel of the drive will turn on sequentially from top to bottom. All LEDs
will remain ON for a few seconds.