9
BATTERIES RECHARGING
WITH
ON-BOARD
CHARGER
(OPTIONAL)
Bring the machine on a levelled surface near to a single-phase socket
with tension 230V, frequency 50Hz, nominal current 10A.
Switch off the switches of the brushes motor, the suction motor and
the solenoid valve.
1.
Insert the plug into the mains socket.
2.
Proceed to the recharging keeping the seat base lifted (see
under paragraph “ACCESS TO THE BATTERY COMPARTMENT” in
“BEFORE USE”).
3.
Do not take off the plug from the mains socket until the
indication of the end of charge is not visualized.
At the end of the recharging, take off the plug from the mains
socket.
Never charge a GEL battery with a non suitable recharger. Strictly
follow the instructions supplied by the batteries and recharger
manufacturer.
In order not to cause permanent damages to the batteries, it is
necessary to avoid their complete discharge, providing for the
recharging within a few minutes after that the batteries’ discharge
signal starts blinking.
NOTE: Never leave the batteries completely discharged even if the
machine is not used. In case of traditional batteries, please check the
electrolyte level every 20 recharging cycles and eventually top them
up with distilled water. Never leave the batteries discharged for more
than two weeks.
Danger of gas exhalations and emission of corrosive liquids. Fire
danger: do not approach with free flames.
BATTERIES DISPOSAL
It is compulsory to hand over exhausted batteries, classified as
dangerous waste, to an authorized institution according to the
current laws.
CONNECTION BATTERIES' CONNECTOR AND SWITCHING ON OF
THE MACHINE
Once that the battery recharging has been completed:
1.
Disconnect the connector of the battery recharger from the
battery connector (1).
2.
Connect instead the machine connector (2).
BATTERIES CHARGE LEVEL INDICATOR
To start any function of the machine, it is necessary to rotate
clockwise the key switch (A). Rotating it counterclockwise any
function will be switched off.
WHEN THE MACHINE IS SWITCHED ON, ON THE DISPLAY (1) APPEAR
IN SEQUENCE THE FOLLOWING INFORMATION:
1.
the machine model (for example AdL).
2.
the setting of the battery check card which can be:
GE 24 (check card set for GEL batteries).
or
Pb 24 (check card set for lead batteries).
