18
SQUEEGEE “V” TYPE (OPTNIONAL)
Alternatively to the standard squeegee, a “V”-shaped squeegee is
available, especially indicated for floors with large joints.
This squeegee is interchangeable with the standard one, same
assembly on the machine, same adjustment in height, pressure and
inclination.
Different though are the methods in assembly and disassembly of the
squeegee rubbers.
SQUEEGEE “V” (OPTNIONAL): REAR RUBBER REPLACEMENT
Check the squeegee rubber wear and eventually turn or replace it.
For the replacement it is necessary to:
1.
Lift the squeegee (see under paragraph “STOP OF THE MACHINE
AFTER CLEANING OPERATION”).
2.
Unscrew the tie rods (1) on the terminals (2) of the rubber
holder blade and disengage the terminals.
3.
Unscrew the wing nuts (3) and take off the rubber holder blade
(4).
4.
Turn the rubber (5) to a new side or replace it.
To reassemble the squeegee repeat reverse the operations above
mentioned, inserting first the rubber (5) into its guides, then
positioning the rubber holder blade and finally screwing down all
wing nuts and the tie rods of the two terminals.
SQUEEGEE HOSE CLEANING
Weekly or in case of insufficient suction, it is necessary to check that
the squeegee hose is not obstructed. Eventually, to clean it, proceed
as follows:
1.
Take off the hose (1) from the squeegee coupling.
2.
Wash the inside of the hose with a water jet.
3.
To reassemble the hose repeat inversely the above-mentioned
operations.
CLEANING SOLUTION TANK AND OUTER FILTER
1.
Bring the machine to an appropriate place for the detergent
solution draining.
2.
Unscrew the solution tank cap (1).
3.
Unscrew the cap of the exhaust filter (2) and take off the filter.
Be careful not to lose the gasket of the cap.
4.
Open the solution valve (see under paragraph “FLOW
ADJUSTMENT OF THE DETERGENT SOLUTION”), so that the
detergent solution flows down into appropriate containers.
5.
Rinse with a water jet the solution tank and the components of
the filter.
6.
Reassemble all parts.
NOTE: in case of need it is possible to wash only the components of
the outer solution filter as above-mentioned by closing the solution
valve adjustment (see under paragraph “FLOW ADJUSTMENT OF THE
DETERGENT SOLUTION”), so that the detergent solution remains in the
solution tank.
TWO-MONTHLY MAINTENANCE
FRONT SQUEEGEE RUBBER CHECK
Check the wear of the squeegee rubber and eventually replace it.
For the replacement it is necessary to:
1.
Take off the squeegee (see under paragraph “SQUEEGEE
CLEANING”).
2.
Unscrew the wing nuts in the front part of the squeegee.
3.
Take off the rubber holder blade.
4.
Replace the front rubber.
5.
Reassemble all parts.
SQUEEGEE “V”: FRONT RUBBER REPLACEMENT
Check the squeegee rubber wear and eventually replace it.
For the replacement it is necessary to:
1.
Disassemble the squeegee from the support as indicated under
“SQUEEGEE CLEANING”.
2.
Unscrew the tie rods (1) on the terminals (2) of the rubber
holder blade and disengage the terminals.
3.
Unscrew all wing nuts (3) and take off the rubber holder blade
(4).
4.
Take off the rubber (5) and replace it.
To reassemble the squeegee repeat reverse the operations above
mentioned, inserting first the rubber (5) into its guides, then
positioning the rubber holder blade and finally screwing down all
wing nuts and the tie rods of the two terminals.
