the transceiver.
2.To prevent interference, listen on the channel before
transmitting by pressing and holding [
PKEY
] key (Default:
Monitor
).
3.When ready to begin transmitting, press and hold [
PTT
] switch
and speak in a normal voice level.
●
The TX/RX indicator on the top panel lights red and S/RF meter shows
the output power level.
●
Speaking too close to the microphone, or too loudly, may increase
distortion and reduce intelligibility of your signal at the receiving
transceiver.
4.When you finish speaking, release [
PTT
] switch to receive.
Note
:
If you transmit continuously for more than 3 minutes (Default setting of
TOT
), the internal time-out timer generates a warning beep and the
transceiver stops transmitting. In this case, release [
PTT
] switch and let
the transceiver cool down for a while, then press [
PTT
] switch again to
resume transmitting.
MENU OPERATION
Menu Access
1.In VFO/MR/CH mode, press [
MENU
] key to enter Menu mode.
●
The menu appears.
2.Use the [
UP
]/[
DOWN
] key to select the desired Menu Number.
3.Press [
F
] key to confirm the selection
4.Then use the [
UP
]/[
DOWN
] key to switch ON/OFF or select
numeric values.
5.Press [
F
] key again to complete the setting.
6.Press any key other than [
PKEY
],[
LAMP
], [
UP
]/[
DOWN
] and [
F
]
key to exit menu mode.
Note
:
In this manual, when you enter and use menu system to select, or want to
activate the second function when press [
F
] key with other keys, Please
make sure the operation in 10 seconds after pressing [
F
] key. Otherwise,
the transceiver will turn back to original working mode.
