Changing Deposit Size, Making Beads
The dot size is determined by the tip diameter, the air pres-
sure output setting and the pulse time. For large dots, use a
large tip, higher pressure and more time. Usually, you want to
use as short a time pulse as possible. To increase the dot
size, slightly increase output air pressure, or increase tip size,
or increase both.
Dot Test with Green Tapered Tip #TTN18
First, follow the settings illustrated on the right, and you will
get dots about the size shown. Try other times and pressures
to see how easy it is to get just the dot size you want.
Dot Test with Blue Tapered Tip #TTN22
These tests show the effect of using a smaller diameter tip.
Replace the green tip with the blue (22 gage) tapered tip.
Now, turn on the timer bypass switch and press the foot pe-
dal to fill the tip. Then, turn off the timer bypass switch
(yellow light out) and press the foot pedal.
To make beads, press the timer bypass switch (yellow light
on). With the tip in contact with the test sheet, press and hold
down the foot pedal while making a bead or stripe.
Programmable Timer
Each TS9150 dispenser has a rotary timer with adjustable
time ranges. The DIP switch that controls the timer has been
set at the factory for a time range of 0.01 to 1.0 second, with
the initiation set to MOMENTARY contact. If a longer time
range is required, or foot pedal operation needs to be
changed from momentary to maintained, choose the appro-
priate dip switch setting in the chart below.
