Industrial
Electronic Devices
ADFweb.com S.r.l.
User Manual
SNMP Agent / LoRaWAN Gateway
Document code: MN67F41_ENG Revision 1.000 Page 18 of 33
L
O
R
A
WAN:
This section is used to define the general parameters of LoRaWAN. The means of the
fields are:
In the field “
RF Band
” the wireless band used for LoRaWAN communication is
defined;
In the field “
Network Type
” the type of LoRaWAN network is defined;
In the field “
Diagnostic Position
” it is possible to define an offset into the
internal memory array where the status of the LoRaWAN end devices configured
is saved. The diagnostic is made bit to bit, so each bit will represent a status of a
single end device:
o
1
End device connected;
o
0
End device not connected.
The bits’ order will be the same of the end devices’ definition inside the LoRaWAN Access section;
In the field “
RX2 Datarate
” the data rate on RX2 window is defined.
SNMP:
The means of the fields for “SNMP Agents” are:
In the field “
IP ADDRESS
” the IP address of SNMP side of the converter is defined;
In the field “
SUBNET
Mask
” the SubNet Mask of SNMP side of the converter is
defined;
In the field “
GATEWAY
” the default gateway of the network is defined. This feature
can be enabled or disabled pressing the Check Box field. This feature is used for
going out of the net;
In the field "
SNMP Name of Station
" the name for SNMP Agent station is defined;
In the field "
Contact
" the contact for SNMP Agent station is defined;
In the field "
Location
" the location for SNMP Agent station is defined;
In the field “
Version
” the version of SNMP is defined;
Figure 3d: “Set Communication
LoRaWAN” window
Figure 3: “Set Communication
SNMP Agent” window