Industrial
Electronic Devices
ADFweb.com Srl – IT31010 – Mareno – Treviso INFO:
www.adfweb.com
Phone +39.0438.30.91.31
User Manual
PROFINET / KNX
Document code: MN67818_ENG Revision 1.000 Pagina 17 di 23
If the field “
On Timer
” is checked, the gateway sends the KNX command cyclically;
In the field “
Poll Time
” the delay in ms between two KNX commands is defined (if “On Timer” is checked);
In the field “
Position
” insert the address of the internal array where placing the information;
In the field “
Bit Mode
” insert the start bit of the first byte of the field “Position” where start to insert the data read;
In the field “
Lenght
” the dimension of the KNX message is defined;
In the field “
Mnemonic
” the description for the request is defined.
Note:
If the field “On change” is checked and the “Poll Time” is different from 0, the converter sends the KNX command cyclically and also
when the data is changed.
Note:
If the field “OnCMD”, “OnChange” and “OnTimer” are not checked, the converter only sniffs the bus in order to monitor the status of
the KNX message.
XML FILE:
By Pressing the “
PROFINET XML
” button from the main window for
SW67818 (Fig. 2) it is possible to generate the xml file to be imported
into the master PROFINET.
Figure 5: “PROFINET XML File Name” window
