Industrial
Electronic Devices
ADFweb.com Srl – IT31010 – Mareno – Treviso INFO:
www.adfweb.com
Phone +39.0438.30.91.31
User Manual
J1939 / KNX
Document code: MN67810_ENG Revision 1.001 Pagina 16 di 26
SET COMMUNICATION:
This section define the fundamental communication parameters of two buses, KNX and J1939.
By Pressing the “
Set Communication
” button from the main window for SW67810 (Fig. 2) the
window “Set Communication” appears (Fig. 3).
The window is divided in three sections, one for the KNX, one for the J1939 and the other for Ethernet.
The means of the fields for “KNX” are:
In the field “
Type
” the type of KNX is defined (fixd to ‘KNX TP’);
In the field “
ID Device
” the ID of the KNX side of the converter is defined.
The means of the fields for the “J1939” section are:
In the field “
Baudrate
” the baudrate for the J1939 line is defined;
In the field “
TimeOut Data (s)
” a time is defined. When this time is elapsed, the data on KNX
side are set to 0xFF;
If the field “
Enable
Peer to Peer
” is checked, the converter accepts any ID that have the PGN
inserted in the section “Receive Frames”;
In the field “
Device ID J1939
” the ID for J1939 side of the converter is defined.
The means of the fields for “Ethernet” are:
In the fields “
IP ADDRESS
” the IP address of the converter is defined;
In the fields “
SUBNET
Mask
” the SubNet Mask of the converter is defined;
In the fields “
GATEWAY
” the default gateway of the net is defined. This feature can be enabled
or disabled pressing the Check Box field. This feature is used for going out of the net.
Figure 3: “Set Communication” window