Industrial
Electronic Devices
ADFweb.com S.r.l.
User Manual
Modbus Slave / Modbus TCP Master
Document code: MN67510_ENG Revision 2.100 Page 31 of 38
Note:
When you install a new version of the software, if it is the first time it is better you do the update of the Firmware in the HD67510
device.
Note:
When you receive the device, for the first time, you also have to update the Firmware in the HD67510 device.
Warning:
If Fig. 11 appears when you try to do the Update try these points before
seeking assistance:
Check if the serial COM port selected is the correct one;
Check if the serial cable is connected between the PC and the device;
If you are using a USB
RS232 converter try with a native COM port or
change the converter;
Try to repeat the operations for the updating;
Try with another PC;
Try to restart the PC;
Check the LAN settings;
If you are using the program inside a Virtual Machine, try to use in the main
Operating System;
If you are using Windows Seven, Vista, 8, 10 or 11 make sure that you have
the administrator rights;
In case you have to program more than one device, using the "UDP Update",
you have to cancel the ARP table every time you connect a new device on
Ethernet. For do this you have to launch the "Command Prompt" and write the
command "arp -d". Pay attention that with Windows Vista, Seven, 8, 10, 11 you
have to launch the "Command Prompt" with Administrator Rights;
Pay attention at Firewall lock.
Warning:
In the case of HD67510 you have to use the software “SW67510”:
www.adfweb.com\download\filefold\SW67510.zip
.
Note:
The minimum version of the configuration software must be the 2.000.
Figure 11: “Protection” windows
