Instruction Manual
2
Safety and Warranty
GAS PRESSURE
The appliance and its individual shutoff valve (to be supplied by user) must be disconnected from the gas supply
piping system during any pressure testing of that system at test pressures in excess of
½
psi (3.45 kPa). The
appliance must be isolated from the gas supply piping system by closing its individual manual shut-off valve during
any pressure testing of the gas supply piping system at test pressures equal to or less than
½
psi (3.45 kPa).
•
For your safety, do not store or use gasoline or other flammable vapors or liquids in the vicinity of this or any
other appliances. Keep the area free and clear of combustible.
•
Improper installation, adjustment, alteration, service or maintenance can cause property damage, injury, or
death. Read the installation operating and maintenance instructions thoroughly before installing, or servicing
this equipment.
•
Instructions must be posted in a prominent location. All safety precautions must be taken in the event the
user smells gas. Safety information can be obtained from your local gas supplier.
•
These models are designed, built, and sold for commercial use only. If these models are positioned so the
general public can use the equipment, make sure that cautions, warnings, and operating instructions are
clearly posted near each unit so that anyone using the equipment will use it correctly and not injure
themselves or harm the equipment.
•
A factory authorized agent should handle all maintenance and repair. Before doing any maintenance or
repair, contact your authorized service representative.
•
This product is intended for commercial use only. Not for household use.
•
Installation must comply with all local codes.
DANGER: This warns of imminent hazard, which could result in serious injury or death.
WARNING: This refers to a potential hazard or unsafe practice, which could result in serious injury or death.
Installation
•
If the U burner does not ignite, open the pilot valve more.
•
If the pilot flame appears larger than necessary, turn it down and reset burner ignition.
•
The pilot flame should be as small as possible but large enough to guarantee reliable ignition of the burners
when the knobs are turned to
“
I
”
Note: Please check leakage before re-installing the control-panel.
