Adeunis RF SIGFOX SENSORS, Руководство пользователя

Страница: 44 / 45

SIGFOX SENSORS - Mode d’emploi / User guide version V2.1.1
44 Page of 45
GB
4.1.4 Status
• Low bat error = 1 if supply voltage <= 2.5 V, else 0
• Configuration switch error = 1 if no switch consistency, else 0
• HW error = 1 if hardware failure, else 0
• Configuration done = 1 if last downlink frame was a right frame and configuration done, else 0 (this byte is set to 1 during the next 3
frames following a correct downlink frame)
Alarm/Status Bit7 Bit6 Bit5 Bit4 Bit3 Bit2 Bit1 Bit0
Frame counter HW Switch Low bat Configuration
No error
0x0 à 0xF
0 0 0 0
Low bat error 0 0 1 0
Configuration Switch error 0 1 0 0
HW error 1 0 0 0
Configuration done 0 0 0 1
4.2. Parametres
Name Default value Possible values Data size
Device Type 0 0 : None
1 : Sensors 8 bits
Transmit period 0 0 = Switch
1 to 43200 seconds 16 bits
Debounce Time 0 0 = Switch
1 to 65 seconds 16 bits
Channel On/Off
1 channel = 1 sensor /
pulse counter
0 0 : all channel Off
1 : channel 1 On
2 : channel 2 On
3 : : channel 1 and 2 On 8 bits
Channel 1 Type 0 0 (0x00) = Sensor (selection by switch)
1 (0x01) = Sensor analog, auto mode (0/10V or 4/20mA)
2 (0x02) = Sensor Dry Contact
11 (0x0B) = Sensor 4-20 mA
12 (0x0C) = Sensor 0-10V 8 bits
Channel 2 Type 0 0 (0x00) = Sensor (selection by switch)
1 (0x01) = Sensor analog, auto mode (0/10V or 4/20mA)
2 (0x02) = Sensor Dry Contact
11 (0x0B) = Sensor 4-20 mA
12 (0x0C) = Sensor 0-10V 8 bits
Switch value 0 0x00 to 0x3F
0x00 to 0x3F = DIP switchs position
0 switch set to OFF
1 switch set to ON
Order switchs : SW1-SW2-SW3-SW4-SW5-SW6 8 bits
IMPORTANTE NOTE 1 : A value under 600 secondes cannot be used for the transmit period to respect the radio compliance. For the digital
product make sure the application is compliance too.