IF YOU HAVE...
Page 2
Install product as supplied.
Patented New Zealand No. 605175
INSTALLING THE VENTURI JET:
Using the Allen Key provided, screw the Venturi Jet into the inlet thread end first.
The Allen Key is a tight fit and will require a hard push to fully engage in the jet.
Ensure the Venturi Jet
is screwed in firmly thread
end first until the mark
on the key aligns with the
end of the mixer outlet.
IMPORTANT
Please note:
Do not throw away the other
Venturi Jets as they may be
required at a later date.
Ask the homeowner to keep
with the warranty information.
(A)
(B)
(C)
2. Follow this flowchart to select the correct Venturi Jet for the pressure situation:
20-35kPa
GREEN
JET
Recommended for 20-35kPa
hot water supply.
36-75kPa
YELLOW
JET
Recommended for 36-75kPa
or greater hot water supply.
Please note:
Performance of the mixer will vary based on the specific pipework between your hot water source and the outlet.
76-130kPa
RED
JET
Recommended for 76-130kPa
or greater hot water supply.
1. Check your hot & cold water pressure
EQUAL LOW PRESSURE OR EQUAL HIGH/MAINS PRESSURE
UNEQUAL PRESSURE
START:
Unknown Water Pressure
Yellow Jet
(Hot water pressure 20kPa – 130kPa)
150 - 500kPa
Green Jet
Yellow Jet
Red Jet
COLD WATER PRESSURE:
More than 500kPa
Yellow Jet
(Hot water pressure 20kPa – 130kPa)
20 - 35kPa
76 - 130kPa
HOT WATER PRESSURE:
36 - 75kPa
