Adept Ltd, 2-6 McDonald Street, Morningside, Auckland 1025, New Zealand
Page
3 of 10
www.adeptclip.com
1. Safety
1.1 Introduction
Read and understand all the safety measures and instructions
•
Ensure your hand is clear from the active end of the F4 Inserter before pulling trigger.
•
Never dismantle or attempt to service the F4 inserter without first disconnecting it
from air supply.
1.2 General Description of Operation
The Adept F4 Inserter provides rapid insertion of the Adept Two Flange Plug with greatly
reduced operator effort. The F4 Inserter requires a compressed air supply to operate. The 2
Flange Plug is manually loaded between the 4 arms. Hold the F4 Inserter with your dominant
hand using a pistol grip. Aim the 4 arms for the anus and push firmly forwards so they are
recessed in to approximately 30mm. Pull the trigger while holding the F4 inserter forward
allowing the orange ram to extend to maximum travel. Releasing the trigger will retract the
ram leaving the 2 Flange Plug lodged in the Lamb’s colon.
1.3 Intended Use
•
The Adept F4 Inserter is intended to insert Adept plastic or soluble Two Flange Plugs
only.
•
Recommended air pressure range is 80 PSI to 120 PSI.
1.4 Warnings
•
Use of F4 Inserter without an appropriate spring balancer suspension may induce
operator fatigue.
•
Only use Adept Two Flange Plugs with this product.
•
Only use replacement parts specified in the spare parts list.
•
Use of air pressure outside the range of 80PSI to 120PSI will compromise operation.
2. Installation
2.1 Compressed Air Connection
The compressed air supplied to the dispenser must be
clean and dry
. We recommend
using a water trap filter to achieve the best air. Recommended operating air pressure is 100
PSI.
