INSTRUCTIONS FOR OPERATION
Tightening Bolt
CAUTION:
Point the bolt to threaded hole as vertically as
possible.
Place the socket in the bolt head and apply
pressure to the tool. Start the tool slowly and then
increase the speed gradually. Release the switch trigger when the bolt fixed tightly. (Fig. 1)
Removing Bolt
CAUTION:
Set reversing switch lever for counterclockwise
rotation when removing the bolt.
Place the socket in the bolt head and start the tool to
its full speed. After bolt was removed completely,
release the switch trigger slowly. (Fig. 2)
Installing or Removing Socket
CAUTION:
Before installing or removing the socket, always
disconnect the battery from the tool or set the
reversing switch lever to the center position.
After installing, pull the socket in reverse direction
to make sure it is tightly installed on the square
drive, or it may fall which may cause personal
injuries.
To install the socket, insert it to the end of square drive. Insert the pin and cover it with a rubber
ring. (Fig. 3)
To remove the socket, uncover the rubber
ring and pill out the pin. Then pull the socket
as the direction of arrow.
(Fig. 4)
Switch Action
CAUTION:
Before inserting the battery into the tool,
always check to see that the switch trigger
actuates properly and returns to the “OFF”
position when released. (Fig. 5)
Do not run the toll at low speed for a long
tome, or the tool will be overheated.
To start the tool, simply pull the switch
trigger and keep it pressed
Tool speed can be variably adjusted
depending on how far the switch trigger is
pressed. Light pressure on the switch trigger results in a low rotation speed and further pressure
results in an increase in speed.
Release the switch trigger to switch off the tool.
Reversing Switch Action
CAUTION:
Always check the direction of rotation
before operation. (Fig. 6)
Operate the reversing switch only after
the tool comes to a complete stop. Changing
the direction of rotation before the tool stops
may damage the tool.
Содержание MAC AFRIC SWRENC-001
Страница 1: ......
