ADENDORFF DWHPW2200, Руководство по эксплуатации, Страница: 23 / 28

PUMP
1. Drain all water from high pressure hose, coil it, and store it in cradle of the pressure washer
handle.
2.
Drain all water from spray gun and spray wand by holding spray gun in a vertical position
with nozzle end pointing down and squeezing trigger. Store in gun/hose holder.
3.
Store chemical hose, high pressure hose, spray gun, and spray wand so they are
protected from damage, such as being run over.
It is recommended that you follow these steps to protect the internal seals of the
pressure washer when STORING THE UNIT FOR MORE THAN 30 DAYS AND/OR
WHEN FREEZING TEMPERATURES ARE EXPECTED.
4. Obtain a funnel, six ounces of *RV antifreeze, and approximately 36 inches
of garden hose with a male hose connector attached to one end.
CAUTION
Use only RV antifreeze. Any other antifreeze is corrosive and can damage pump.
1.
Put the engine speed lever to the stop position.
2. Connect 36 inch length of hose to water inlet of pump
3. Add *RV antifreeze to hose as shown.
4. Pull engine starter rope slowly several times until antifreeze comes out of high
pressure hose connection of pump.
5.
Remove short hose from water inlet of pump.
Windshield washer fluid may also be used
22
I