ADEMCO AHDR1, Руководство пользователя

Страница: 20 / 70

Single-Channel Digital Video Recorder
19
To reset the unit, you will need a straightened paperclip:
1. Turn the DVR off
2. Turn it on again.
3. While the DVR is initializing, poke the straightened paperclip in the unlabeled hole to
the right of the RS232 connector.
4. Hold the switch until all the LEDs and all the segments on the Front Panel Display are
lit.
NOTE: When the DVR successfully resets to factory defaults all the LEDs and
the segments on the Front Panel Display flash three times.
5.
Release the reset switch. All of the DVR’s settings are now at the original settings it
had when it left the factory.
Connecting the Power Cord
Figure 16 — Power cord connector
Connect the power cord to the DVR and then to the wall outlet.
NOTE: The DVR has an auto-selecting power supply.
WARNING: ROUTE POWER CORDS SO THAT THEY ARE NOT A TRIPPING
HAZARD. MAKE CERTAIN THE POWER CORD WILL NOT BE PINCHED OR
ABRADED BY FURNITURE. DO NOT INSTALL POWER CORDS UNDER RUGS
OR CARPET.
THE POWER CORD HAS A GROUNDING PIN. IF YOUR POWER OUTLET DOES
NOT HAVE A GROUNDING PIN RECEPTICLE, DO NOT MODIFY THE PLUG.
DO NOT OVERLOAD THE CIRCUIT BY PLUGGING TOO MANY DEVICES IN TO
ONE CIRCUIT.
Your DVR is now ready to operate. Refer to Chapter 3 — Configuration .