AddPac AP-IP230, Инструкция по установке и эксплуатации

Страница: 24 / 164

AP-IP230 IP Phone Installation Guide Version 1.0
AddPac Technology Proprietary & Documentation
24
Requirements for Network Connection
This procedure is to follow EIA standards and other EMI regulations when you install the Gateway
The following section describes the Ethernet Cable, and the Console Cable which can be connected to
the AP-IP90.
Required Tools and Equipment
Some cables and equipment are not included and your need to purchase them separately. Please
prepare the following tools and equipment
LAN Cable & Console Port Cable

RJ-45 to RJ-45

RS232C console cable with RJ-45 connector (included in the box
Ethernet Port
The AP-IP90 has two RJ45 type of 10/100 BaseTX Ethernet ports on the rear side and LED for
indicating the status of the port on the front. These ports are physically connected and using the direct
cable you can connect to LAN0/ LAN1. Please use the standard cable and connector to access to
LAN. You may refer to the cable details of Appendix in this guide
.
Console Port (Optional)
AP-IP90 has one RJ-45 type3 of RS-232C Female DCE Connector Interface. Through this port, you
can perform the initial setup, monitoring and debugging the system. The cable and connector must be
used. You may refer to the pin connection for RS-232 console cable of appendix in this guide.