www.addonics.com
Technical Support (M-F 8:30am - 6:00pm PST)
Phone: 408-453-6212
Email: www.addonics.com/support/query/
Adding and removing hard drives from the Snap-In Disk Array
Step 1.
Be sure the lock on each drive door is in an unlock position. If
not, use the key that comes with the Disk Array to unlock the drive door.
Pull on the door lever to swing open the drive door all the way.
Step 2.
Slide a 2.5” SATA hard drive into the drive slot with the drive
connector side facing in. Be sure to insert the hard drive with the hard
drive label facing up. The drive should slide all the way into the slot with
very little resistance. Forcing the drive into the slot will cause drive
damage or permanent damage to the Disk Array.
Step 3.
Once the drive is all the way into the drive slot, close the door all
the way till the drive door latch securely. This will engage power and data
connection with the hard drive. The LED lit for the drive slot should lit if
the Disk Array already powered on. You may lock the drive door with the
key.
Step 4.
To remove the hard drive from the Disk Array, simply follow the
step 2 – 3 in reverse.
