Addictive audio 100.1D, Руководство по установке и инструкция по эксплуатации

Страница: 11 / 32

11
ly stable to 2ohm mono.
occurs:
Reverse Voltage (Immediately)
ately illuminate yellow when clipping is detected. The brighter and
This allows the supplied 6P phone cable (Data Link) to pass signal
through to the Slave amplifier. This must be used when strapping
two amplifiers.
CAUTION: Strapped amplifiers are on
12. Master / Slave Selection
When strapping two amplifiers together the Master amplifier must be set
to MAS and Slave amplifier must be set to SLV via this switch.
13. Power / Protection / Clipping Indicator LED
POWER LED: Will illuminate GREEN when +12VDC is applied to both the remote turn on
and +12V input from the battery and a solid ground has been made. The input
from the battery to the amplifier can be more than 12VDC.
PROTECTION: Will illuminate RED when any one of the following
Short
Circuit (Immediately)
Thermal (On at 141*F or 60*C)
Low Voltage (On at 9VDC)
High Voltage (On at 18VDC)
CLIPPING: Will immedi
more solid the LED is lit = the more potential damage to the speakers.
C may be heard as general distortion or as pops. The untrained ear often over looks lipping
this. Because the clipped waveform has more area underneath it than the smaller unclipped
waveform, the amplifier produces more power when it is clipping. This extra power can
d
any part of the loudspeaker, including the woofer or the tweeter, by causing over- amage
ex n, or by overheating the voice coil . Addictive Audio uses the CLIPPING LED to cursio
he E” when clipping occurs, without this, our only other option would be to give lp “SE
ev an oscilloscope. eryone
r
1.
nection does not occur during the installation process.
2. t attach the
battery until all wires have been plugged into
nter clockwise).
Hz (7 clicks), set the
rt
Adjusting the Amplifie
Disconnect the negative battery post and secure it to something so
accidental re-con
Run all wires needed for the amplifier to work correctly. Do no
fuse in the fuse holder by the
the amplifier.
3. Turn the amplifiers gain and boost all the way down (cou
4. As a good “starting point” set low pass filter to 80
subsonic to the tuning frequency of your enclosure
(refer to EASY CLICK cha
r exact tuning)
, and set the phase to 0.
on pg.13 fo