ADCMT 4601 I-V Meter, Руководство по эксплуатации

Страница: 89 / 236

4601 I-V Meter Operation Manual
4.2.10 MENU Key (Parameter Setting)
4-9
3) Load @ PWR On Selects the setting parameter condition at power ON.
Saved @ PWR Off Start up using the parameters saved when the power was
last turned off.
User-0 Saved Start up using the parameters saved in the non-volatile
memory, User-0.
H) INTERFACE Selects and sets the interface.
1) Interface Bus Selects either the GPIB interface or the USB interface.
GPIB interface:
2) GPIB Address Sets the GPIB address from 0 to 30.
GPIB interface:
2) USB Id Sets the USB ID from 1 to 127.
3) Header Sets the header of the talker format to ON or OFF.
4) Output Format Selects the output format between ASCII and BINARY.
5) Output Vm Data Sets whether the Vm data (ADC1 measured value) is output or not.
On: Output
Off: No output
6) Output Im Data Sets whether the Im data (ADC2 measured value) is output or not.
On: Output
Off: No output
7) Output ADC3 Dt Sets whether the ADC3 measured value is output or not.
On: Output
Off: No output
I) MAINTENANCE Sets the maintenance and inspection-related parameters.
1) Self Test Executes the self test.
For more information, refer to Section 5.7, "Self Test."
2) Disp/Key Test Executes a test for the display and the panel keys.
For more information, refer to Section 5.7, "Self Test."
3) Calib. Mode Selects the calibration mode.
On: Sets the status in which source values and measured values are
calibrated.
For more information, refer to Chapter 8., "CALIBRATION."
Off: Sets the normal measurement status.
4) Counter Select Selects the relay counter.
5) Relay Counter Displays the relay ON/OFF count stored in the selected relay counter.
6) Reset Counter Clears the selected relay counter.
7) Serial Number Displays the serial number.