ADCP-80-531 • Issue 4 • July 2004
Page 16
© 2006, ADC Telecommunications, Inc.
2
ACCESSORIES
The following accessories for the PowerWorx Select Series circuit breaker panel are available:
• Circuit breakers. Current capacity of 1, 3, 5, 10, 15, 20 Amps with choice of two delay
values (instant and short).
• Cable management bar with mounting screws. Provides cable tie points. Installed at rear
of circuit breaker panel by fastening ends of bar to both sides of the panel
• Three sizes of two-hole compression lugs for #2, #4, and #6 AWG wire for input power
connection
• Lug terminals to connect #10 AWG wire to earth ground
• Circuit breaker designation card kit
• Spare circuit breakers for field-replacement
3
UNPACKING AND INSPECTION
Unpack and inspect the various components as follows:
1. Inspect the exterior of the shipping container for evidence of handling that may have
damaged the components in the container.
2. Unpack each container while carefully checking the contents for damage and verify with
the packing slip.
3. File a claim with the commercial carrier and notify ADC Customer Service if damage is
detected or if parts are missing. Save damaged cartons for inspection by the carrier.
Section 8, Customer Information and Assistance
at the back of this manual, for
repair, replacement, and warranty information.
5. Save all shipping containers for use if the equipment requires return shipment at a future date.
4
INSTALLATION
Circuit Breaker panels must be installed in a central office, equipment room, or restricted access
location.
The following guidelines should be used when mounting the circuit breaker panel in a rack.
• Mount the circuit breaker panel in the uppermost area of the rack to reduce exposure of the
power wiring.
• Provide a minimum of 1.75 inches (4.45 cm) of air space (one rack space) between the top
of the circuit breaker panel and the next item in the rack for cooling.
• Adding a circuit breaker panel to a rack may displace a device which may require
relocation.
