Page 4 of 4
FCC C
LASS
A C
OMPLIANCE
This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications. Operation of this equipment in a residential
area is likely to cause harmful interference in which case the user will be required to correct
the interference at his own expense.
L
IMITED
W
ARRANTY
Product warranty is determined by your service agreement. Refer to the ADC Warranty/
Software Handbook for additional information, or contact your sales representative or
Customer Service for details.
M
ODIFICATIONS
Any changes or modifications made to this device that are not expressly approved by ADC
Telecommunications, Inc. voids the user's warranty. All wiring external to the products should
follow the provisions of the current edition of the National Electrical Code.
S
TANDARDS
C
OMPLIANCE
This equipment has been tested and verified to comply with the applicable sections of the
following safety standards:
• GR 63-CORE - Network Equipment-Building System (NEBS) Requirements
• GR 1089-CORE - Electromagnetic Compatibility and Electrical Safety
• Binational standard, UL-60950/CSA C22.2 No. 60950-00: Safety of Information
Technology Equipment.
W
ORLD
H
EADQUARTERS
To contact ADC by mail:
ADC Telecommunications, Inc.
PO Box 1101
Minneapolis, MN 55440-1101
T
ECHNICAL
S
UPPORT
Technical assistance is available 24 hours a day, 7 days a week by contacting the ADC
Technical Assistance Center (TAC) at:
Telephone:
800.366.3891 (toll-free in the U.S. and Canada)
E-mail:
Knowledge Base:
www.adc.com/Knowledge_Base/index.jsp
Web:
www.adc.com
!
IMPORTANT
To comply with the intrabuilding wiring requirements of GR-1089 CORE, Section
4.5.9, the shields of the ABAM-type cables that connect the line unit DSX-1 output
ports to the cross-connect panel must be grounded at both ends.
M
EGABIT
M
ODEM
® MM702G2-W V5.
X
Quick Installation Guide
Product Catalog: MM702G2-W
Document: MM702G2-W-QI-02
Issued March 20, 2009
´.4+¶5o¨
1420115
R
EVISION
H
ISTORY
Copyright © 2009 ADC Telecommunications, Inc. All rights reserved.
ADC and Megabit Modem are a registered trademarks of ADC Telecommunications, Inc. No right, license, or interest to
such trademarks is granted hereunder, and you agree that no such right, license, or interest shall be asserted by you with
respect to such trademark.
Other product names mentioned in this practice are used for identification purposes only and may be trademarks or
registered trademarks of their respective companies.
Information contained in this document is company private to ADC Telecommunications, Inc., and shall not be modified,
used, copied, reproduced or disclosed in whole or in part without the written consent of ADC.
Contents herein are current as of the date of publication. ADC reserves the right to change the contents without prior
notice. In no event shall ADC be liable for any damages resulting from loss of data, loss of use, or loss of profits, and ADC
further disclaims any and all liability for indirect, incidental, special, consequential, or other similar damages. This
disclaimer of liability applies to all products, publications and services during and after the warranty period.
Rev Date
Revisions
01
7/25/2008
Initial release.
02
3/20/2009
Technical update.
