ADC Mobile
Car Show Installation Guide – GM Series
ADC Mobile Car Show GM1210 Multi-Media Navigation System Installation Guide
Page 9
CAN Module Placement
The foam-wrapped CAN module
contains the speaker that
reproduces the chime and turn
signal sounds. Depending on
where this is placed will
determine speaker volume.
CHECK CHIME AND TURN
SIGNAL VOLUME BEFORE
FINALIZING THE
INSTALLATION!
Reinsert Radio into Dashboard
You will notice that there are many more harnesses and connectors on the Car Show
system than there were on the factory radio – these all now need to find a home in order
for the radio to fit properly in the dash.
Take your time and be patient
locating the harnesses and connectors in the dashboard!
They will all fit – trust us! Bose vehicles generally use more of the supplied harnesses
and have less room to fit them all into – On Bose vehicles, we recommend that you
PATIENTLY
locate all connectors and harnesses out the bottom “slot” in the radio
opening. It is
CRITICAL
that no harnesses or connectors be located directly behind the
radio chassis – the radio
WILL NOT FIT
in the radio opening if there is any obstruction
behind it, and you may damage the radio if you force it into the opening!
Re-install Radio Mounting
Bolts
Use 7mm socket to re-install 4 x
7mm radio mounting bolts
Re-install Climate
Controls
Use 7mm socket to re-install 2 x
7mm radio mounting bolts
Turn the vehicle ON and
confirm the unit is fully
operational
With the connectors
Fully
Engaged
, turn the vehicle on and
press the
RESET
located at lower
right corner of radio face
