ADC AD-464, Руководство по обслуживанию

Страница: 42 / 96

38
WARNING: ALL SERVICE and TROUBLESHOOTING SHOULD BE PREFORMED BY
A QUALIFIED PROFESSIONAL or SERVICE AGENT.
WARNING: WHILE MAKING ADJUSTMENTS, OBSERVE ALL SAFETY
PRECAUTIONS DISPLAYED ON THE DRYER or SPECIFIED IN THIS
MANUAL.
6) Reestablish electrical service to the dryer.
Proceed to Retaining Wheel Adjustment instructions immediately below.
h. Retaining Wheel Adjustment
1) With the dryer operating, turn the off-set hex hub on the retaining wheel until the wheel lightly spins,
then stops as the tumbler (basket) rotates. (This is the proper adjustment of the retaining wheels.)
NOTE : Over compression of the retaining wheels against the tumbler (basket) will cause premature
failure of the retaining wheels.
2) Tighten the 3/8-16 hex nut on the bolt once the proper adjustment has been achieved.
3) Discontinue electrical service from the dryer.
4) Replace the front or the rear loading door panels.
5) Reestablish electrical service to the dryer.
i. Drive Shaft Replacement
1) Discontinue electrical service to the dryer.
2) Follow Step #2 thru Step #7 of the Gear (Speed) Reducer Replacement instructions on page 35
and page 36 .
3) Carefully place the gear (speed) reducer on the floor and continue to remove the drive shaft from the
dryer.
4) Measure ALL scribe marks from the old shaft and transfer the marks on to the new drive shaft for
proper component replacement.
5) To install new drive shaft reverse Step #4 thru Step #2 .
CAUTION: USE EXTREME CARE WHEN SETTING RETAINING WHEEL TENSION.
PERSONAL INJURY MAY RESULT.
NOTE : Proper retaining wheel tension has been achieved when the wheel spins and stops when a slight
pressure is applied (to the retaining wheel itself).
6) Reestablish electrical service to the dryer.