ADC 150-2205-04, Инструкция по установке и проверке

Страница: 78 / 112

800-357-104-01, Revision 01
66 September 29, 2000 HMS-357 List 4 and List 5
HXU
-36
9
Placing the Line Unit in Service Using an HXU-369 Multiplexer
Enabling Alarms for Systems Using an HXU-369 Multiplexer
Step Procedure Installer Check
ü
ü ü
ü
The following procedure assumes proper TAO login.
For proper login procedure, please refer to
“Using the Terminal Access Option” on
page 27 .
1 From the Shelf Options screen, select .
H
2 Select the Config menu and then press .
H
3 Select the line unit, use the to select IN-SRVC, and then press .
H
4 Proceed to “Enabling Alarms for Systems Using an HXU-369 Multiplexer” .
H
Installer Signature
?
? ?
?
Date
Step Procedure Installer Check
ü ü ü ü
1 From the Shelf Options screen, press to select Alarm Management. The following prompt
appears:
Which Line Unit do you want to change the alarm settings
on (1-28). (E)nable All, (D)isable All
H
2 Enter the slot number of the line unit you want to enable. When you enter a slot number (x), one of
the following prompts appears.
Do you want to ENABLE alarm settings for Line Unit x (Y/N)
Do you want to DISABLE alarm settings for Line Unit x
(Y/N)
H
3 Press an appropriate or response for the alarm setting you are changing.
H
4 If you plan to install a test card, proceed to “Installing a Test Card (HTC) (Optional)” on page 69 .
If you plan to install a cut-through card, proceed to “Installing a Cut-through Card (HCC) (Optional)”
on page 70 .
The Wideband System 3190 should now be operational. If you experience any difficulties at this
time, refer to
“Troubleshooting and System Testing” on page 67 .
H
Installer Signature
? ? ? ?
Date
M
ENTER
SPACEBAR ENTER
A
Y N