ADB Safegate EREL, Руководство пользователя

Страница: 35 / 50

Install - Step 1
1. Make sure that all the parts are clean. Pay extra attention to the parts where the cooling block gasket must fit.
2. Apply adhesive on the first three threads of the threaded holes in the body. Use adhesive C. See §
Options and
accessories .
3. Install the new cooling block gasket (A) on the body (B).
4. Install the new cooling block (C).
5. Push the cooling block towards the arrow to the center line (D).
6. Install the washers (E) and the cooling block screws (F). See §
Screws and torques (torque).
7. Make sure that the cooling blocks on both sides of the fixture are parallel to each other.
Install - Step 2
1. Install the optical kit. See § Part replacement - optical kit .
2. Install the optical cover. See § Part replacement - optical cover .
3. Install the complete optical head. See § Part replacement - complete optical head
4.3.8 Part replacement - body support assembly
Parts: See § Exploded view .
•
Body support assembly
•
Body gasket
Tools:
•
Spanner, size 13
Remove
1. Remove the complete optical head. See § Part replacement - complete optical head .
2. Remove the alignment screws (A).
3. Remove the body support assembly (B).
4. If necessary, remove the cable lead, the Earthing wire and de cable strain relief bushing. See §
Part replacement - cable
lead, Earthing wire and cable bushing .
AM.03.120e, Rev. 3.4, 2019/03/29 29
Copyright
©
ADB Safegate, All Rights Reserved