3
FRONT PANEL
1. Mic1 input (6.3mm phone jack/balanced).
2. Mic1 volume control
3. Mic2 volume control
4. Mic3 volume control
5. Mic4 volume control
6. Music source select (AUX/TUNER/CD-TAPE/OFF)
7. Line (music source) volume control
8. Master tone control (Bass)
9. Master tone control (Treble)
10. Master volume control (All inputs except TEL)
11. Power ON/OFF switch
12. VU meter (LEDs for -20, 6, 09dB)
13. Tuner display
14. Memory keys
15. AM/FM selection key
16. Frequency up/down key
17. Scan key
18. Set memory key
19. Shift key
20. CD or cassette player unit built in slot
21. Zone 1 select switch button
22. Power on indicator LED
23. Zone 2 select switch button.
REAR PANEL
1. 24Vdc power supply terminals
2. Loudspeaker output terminals (8
Ω
/25V/70V/100V)
3. Earth connection screw
4. FM antenna input
5. AM antenna input
6. MOH (Music on hold) output terminal
7. Manual muting terminals
8. TEL (Telephone) input terminals
9. Zone 1 loudspeaker output terminals
10. Zone 2 loudspeaker output terminals
11. Mains input socket
12. Mains voltage 115V/230V selector switch
13. AC fuse holder
14. Line output (2 x RCA phono)
15. Auxiliary input (2 x RCA phono)
16. Mic4 input (XLR/balanced with selectable phantom power)
17. Mic3 input (XLR/balanced with selectable phantom power)
18. MOH output level control
19. Mic2 input (XLR/balanced with selectable phantom power)
20. TEL input level control
21. Mic1 input (XLR/balanced with selectable phantom power)
IMPORTANT
Then wires in the mains lead are coloured in accordance with the
following code:
Green & Yellow:
Earth
(E)
Blue:
Neutral (N)
Brown:
Live
(L)
As the colours of the wires in the mains lead of this apparatus may not
correspond with the coloured markings identifying the terminals in your
plug proceed as follows:
The wire which is coloured green and yellow must be connected to the
terminal which is marked by the letter E or by the safety earth symbol or
coloured green and yellow. The wire which is coloured blue must be
connected to the terminal which is marked with the letter N or coloured
black. The wire which is coloured brown must be connected to the
terminal which is marked with the letter L or coloured Red. If a 13Amp
(BS1363) plug or any other type of plug is used, a 5 Amp fuse must be
fitted either in the plug or at the distribution board.
GENERAL INSTALLATION
DO NOT
run microphone cables near mains, data,telephone or 100V line
cables
DO NOT
run 100V line cables near data, telephone or other low voltage
cables
DO NOT
exceed 90% of the amplifiers output power when using 100V line
(speech only)
DO NOT
exceed 70% of the amplifiers output power when using 100V line
(high level background music)
DO NOT
use re-entrant horn loudspeakers for background music unless the
loudspeaker has been specifically designed for this purpose.
AVOID
Jointing the microphone cable, when this is unavoidable make sure
a good screened connector is used, e.g. XLR
ALWAYS
use a balanced or floating low impedance microphone terminating
into a balanced input on long microphone cable runs.
ENSURE
that all loudspeakers are in-phase
ENSURE
that there are no short circuits on the loudspeaker line before
connection to the amplifier.
WARNING: THIS APPLIANCE MUST BE EARTHED
OPERATION MANUAL - ADASTRA PA5120 SERIES
GB
WARNING: SHOCK HAZARD - DO NOT OPEN
AVIS: RISQUE DE CHOC ELECTRIQUE - NE PAS OUVRIR
C A U T I O N
R I S K O F E L E C T R I C S H O C K
D O N O T O P E N
CD PLAYER
AM / FM TUNER
FUNCTION
MEMORY
REPEAT
RANDOM PROGRAM POWER
PLAY
EJECT
STOP
PAUSE
1
2
3
4
5
6
7
8
9
10
11
12
13 14 15 16 17 18 19
20
21 22 23
1
2
3
4
5
6
7
8
9
10
11
12
13
14 15 16 17 18 19 20 21
Содержание PA5120RC
Страница 2: ...2 ...
