103.146UK User Manual
If an external playback device is to be used, connect this to the AUX IN sockets on the rear panel (11).
The S460-WIFI delivers up to 30W per channel at 8
Ω
to the speaker outputs on the rear panel (17, 18).
There are 2 separate amplifiers (channel 1, channel 2), each with a Left and Right speaker output.
Connect an 8
Ω
speaker to each output with power handling of up to 30W each by unscrewing the binding
posts and securing the
“
+
”
wire to the
“
+
”
post and
“
-
”
wire to the
“
-
”
post for left and right channels.
This drives 2 speakers per zone (L+R), or 4 in total across 2 zones.
Alternatively, connect 2 x speakers (8
Ω
, 30W) in parallel to each output for up to 60W per channel
(shared across the 2 speakers). This drives 4 speakers per zone (L+L+R+R), or 8 in total across 2
zones.
Warning: The minimum impedance load per channel is 4
Ω
.
(2 x 8
Ω
speakers wired in parallel = 4
Ω
)
Note: Suitable speaker cable would be 0.66mm² or 6A rated fig.8 speaker cable.
Operation
When all connections are made, switch the power on (1) to the amplifier and the power switch will light.
All signals through the amplifier are controlled via the media player controls on the front panel (5, 6, 7, 8)
Input modes are determined by the INPUT button. Pressing
this will cycle through the input options.
(WPS will be described on the next page)
If a playback device is connected to the rear panel AUX inputs (7), select AUX mode for this source.
For any input source, hold down l
to reduce output volume or
l to increase the volume.
When a USB pen drive or microSD card is inserted to the relevant port or slot on the front panel (1, 2),
playback will normally start automatically. Otherwise, select USB or SD by pressing the SOURCE button
and then press the
ll button to play the track (press the same button to pause the track).
Navigate through tracks on the USB or microSD using the l
or
l buttons.
To connect a smart phone wirelessly via Bluetooth, select BT using the SOURCE button. Press and hold
the
ll (BT PAIR) button to release any current Bluetooth pairing and enter new pairing mode.
Search for
S460-WIFI
in the smart phone Bluetooth menu and select to pair for audio playback. Once
paired, the display will stop flashing. Playback and navigation can be controlled on the phone or via the
ll, l
or
l buttons.
A handheld I.R. remote control is supplied with the S460-WIFI with controls similar to those on the front
panel and a numerical keypad for direct track selection.
The S460-WIFI amplifier is capable of WiFi streaming, which can access any internet radio station or a
subscription service with pre-determined playlists for continuous playback directly from the internet.
In this mode, the audio stream is initially set up and controlled by a smart phone app.
To enable this feature, select the WIFI option from the SOURCE button and perform the LEGACY PLAYER
setup as shown in the instructions on the following pages.
To reset the S460-WIFI to factory settings, press and hold the WPS button for 5 seconds, then release.
This will disconnect the S460-WIFI from the WiFi network and return the S460-WIFI to factory settings
The S460-WIFI can be paired to any WiFi network by the setup process described in the following pages.
