Replacing the SATA PCI Controller Card
Snap Server 18000
4
Field Service Documentation
Copyright © 2009, Overland Storage, Inc. All rights reserved. Information in this document is subject to change without notice and does
not represent a commitment on the part of Overland Storage or any of its subsidiaries.
Replacing the Card Cage
1
Position the assembly over the server.
2
Make sure the rear of the assembly is aligned with the guides at the rear of the
chassis and lower the assembly into place.
Important!
The two locating pins on the mother board must be directly aligned
with the two connections on the assembly.
3
Place your hands on either side of the card cage assembly handle, one hand near
the rear of the assembly and the other over the fan protectors (refer to illustration
above). Secure the assembly by using both hands to press down firmly until you
hear it click into place.
4
Using the index finger and thumb, firmly grasp the edges of the SATA cable
connector and insert it into the receptacle.
5
Secure the locking mechanism on the connector.
Guides
Place hands at red
arrows to seat
assembly
