Chapter 8: Installing the Driver on an Existing Operating System
●
57
Installing on OpenServer
To install the driver on OpenServer:
1
Start your computer, then insert the driver disk.
2
Begin the driver package installer:
pkgadd -d diskette1
3
At the installer prompt, type
go
.
4
Select
1
for the aacraid package.
5
When the installation is complete, select
q
to quit the installer.
6
Reboot your computer and remove the driver disk.
7
Continue with
Managing Your Storage Space
on page 59
.
Installing on UnixWare
To install the driver on UnixWare:
1
Start your computer, then insert the driver disk.
2
Begin the driver package installer:
pkgadd -d diskette1
3
At the installer prompt, type
go
.
4
Select
1
for the aacraid package.
5
When the installation is complete, select
q
to quit the installer.
6
Reboot your computer and remove the driver disk.
7
Continue with
Managing Your Storage Space
on page 59
.
Installing on Solaris
To install the driver on Solaris:
1
Start your computer.
2
Check for any pre-existing Adaptec driver by performing a
pkginfo SUNWaac
in a terminal
window. If there is no pre-existing Adaptec driver on your computer, continue with
Step 3
. If an Adaptec driver is already installed on your computer, perform a
pkgrm
SUNWaac
to remove it.
Caution:
If your operating system currently boots from the Adaptec controller,
do not
reset your computer after you remove the pre-existing Adaptec driver. Instead, follow
the steps in this section to install a new driver before rebooting your computer.
3
Insert and mount the driver disk:
volcheck
4
Change to the driver installer directory:
cd /floppy/floppy0/DU/sol_210/i86pc/Tools
!