Adaptec 2940U2W - Storage Controller U2W SCSI 80 MBps, Руководство пользователя

Страница: 21 / 42

15
Configuring the SCSI Card 2940U2W with SCSISelect
Configuring the SCSI Card
2940U2W with SCSISelect
SCSISelect, included with the SCSI Card 2940U2W, enables you to
change SCSI settings without opening the computer or handling the
card. SCSISelect also enables you to low-level format or verify the
disk media of your SCSI hard disk drives. Table 1 lists the available
and default settings for each SCSISelect option.
Note:
The default settings are appropriate for most systems.
Run SCSISelect if you need to change or view current set-
tings, or if you would like to run the SCSI disk utilities. See
the descriptions of each option on page 17.
Table 1. SCSI Select Settings
SCSISelect Option Available Settings Default Setting
Basic Host Adapter Settings:
Host Adapter SCSI ID 0-15 7
SCSI Parity Checking Enabled, Disabled Enabled
Host Adapter SCSI Termination:
Ultra2-LVD/SE Connector Automatic, Enabled,
Disabled Automatic
Fast/Ultra-SE Connector Automatic,
Low ON/High ON,
Low OFF/High OFF,
Low OFF/High ON Automatic
Boot Device Settings:
Boot SCSI ID 0-15 0
Boot LUN Number
1
0-7 0
SCSI Device Configuration:
Initiate Sync Negotiation Yes, No Yes (Enabled)
Maximum Sync Transfer Rate 80.0, 53.4, 40.0,
32.0, 26.8, 20.0,
16.0, 13.4, 10.0 80.0
Enable Disconnection Yes, No Yes (Enabled)
Initiate Wide Negotiation Yes, No Yes (Enabled)