TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSES
SPEEDY LIFT
will not run
Bad electrical connections.
Check and clean corrosion from all
connections including the car’s battery cable connections.
Hand pendant wire problem.
Check hand pendant wire to make sure
it is properly plugged. Check the wire for any cuts. If so, replace the
wire.
Burnt out switch.
Replace pendant.
Bad connection.
Check the electronic module under the seat. Make
sure that all the wires are properly connected.
Burnt
out
electronic
module.
Contact Adapt-Solutions for
replacement module.
Burnt out actuator.
Replace actuator.
Power Loss.
The
SPEEDY LIFT
motor is not getting adequate
electrical power because of a loose connection. Check the
SPEEDY
LIFT
connections for tightness and corrosion (especially the ground
connection).
A partially discharged battery in the vehicle.
Check the car’s battery
by trying the car lights or checking the voltage with a voltmeter
(should read 13.2 volts). Clean the car battery posts and cable clamps
thoroughly (remove the battery clamps off the battery posts and clean
them with a wire brush designed for that purpose). Coat the
connection with anticorrosion spray once reassembled. An
automotive battery may be weak, having enough power to start the
car but not enough power for continuous use.
