Adam Sub2100, Руководство по эксплуатации

Страница: 9 / 32

9
Sub2100 Manual / English
On the front side you will find Indicator LEDs for the operating and standby modes.
Controls for the satellite filter, phase switch, signal on/continous mode and Sub
Level/Filter are located on the rear panel of the subwoofer. The following tips are
intended to assist you at using the controls in the best manner.
5.1 LEDs on front panel
There are two LEDs on the front. The upper LED
indicates the operating mode. In case the subwoofer
receives an overload the lower LED will flash red
indicating the function of the protective circuit.
5.2 Controls on the rear panel
a) Subwoofer Phase
With the Phase Switch you can alter the phase of
the subwoofer relative to the satellites. That means
to change the polarity of the bass unit. Depending
on the distance between woofer and satellites,
either 0° or 180° may be the better position. We
recommend to try out what position sounds better
within your system.
b) Satellite Filter
The satellites in a system can be driven full range or with a 85 Hz high
pass as recommended by Dolby® laboratories for use in surround setups.
Recommendation: the main signal should go into the Subwoofer. Connect
your satellites to the Subwoofer output, either via XLR symmetrical or RCA
asymmetrical. In many cases, clarity and dynamic range of the speakers can be
improved if they do not reproduce very low frequencies since they do not have
to deliver big amplitudes.
Please note: If you alter the frequency it is advisable to check if an alteration of the
phase improves the sound quality.
5.
Controls