Adam Equipment MDW - 250L, Руководство пользователя

Страница: 16 / 20

© Adam Equipment Company 2009 Page 15 Rev C3, June 2008
9.0 Error Messages
1.
0 ¯ ¯ ¯ ¯ ¯ zero point is over the setting range
2.
0_ _ _ _ _ zero is below the setting range
3.
Ad
¯ ¯ ¯¯
ADC is over max. range;
4.
Ad _ _ _ _ ADC is below min. range;
5.
EEP.Er there is an error in EEPROM
6.
CAL.Er there is an error in calibration
7.
CAP. -- The capacity will be displayed
8.
Lo.bAt The voltage of batteries or input power is below 5.6V.
9.
FULL The capacity has been exceeded by the person
standing on the scale.
10.0 WARNING
•
Do not dismantle the weighing machine without following the necessary
instructions.
•
Do not jump while standing on the platform. This may damage the sensor
inside.
•
Do not move the weighing machine violently and abruptly. It is
recommended to move and put down the weighing machine gently.
•
It is suggested to wipe the stains with soft cloth soaked with detergent and
to wipe later with soft cloth too. Do not use organic solutions and boiled
water to wipe the stains. Do not use water for cleaning.
•
Keep the weighing machine in a dry and clean environment. Do not
expose it outdoor or use it in locations near fire, under direct sunshine or
with high temperature.
•
When lifting the height meter, it is suggested to pull it straight along the
pipe without using excessive force.