Acurix Networks - User Manual X52-N
Confidential. © 2010 Acurix Networks
Page 28 of 31
authentication occurs. Valid ranges are from 0 to 65535
seconds. The value that you set goes into effect after you
reboot your computer with this profile set as the active
profile. This drop-down menu is active only if you chose
EAP-based authentication.
6. Select
Advanced
tab.
Transmit Power Level
Selects the transmit power level for 80211b/g or 802.11a
in mW. Actual transmit power may be limited by
regulatory domain or hardware limitations. Also note that
administrator has the privilege of locking these power
levels, so that these values are pre-selected and not
editable.
Power Save Mode
Specify:
•
Maximum mode causes the access point to buffer
incoming messages for the wireless adapter. The adapter
periodically polls the access point to see if any messages
are waiting.
•
Normal uses maximum when retrieving a large number
of packets, then switches back to power save mode after
retrieving the packets.
•
Off turns power saving off, thus powering up the
wireless adapter continuously for a short message
response time.
Network Type
Specifies the network as either infrastructure (access
point mode) or ad hoc.
Wireless Mode
Specifies 5 GHz 54Mbps, 5 GHz 300Mbps, 2.4 GHz 54
Mbps, 2.4 GHz 11Mbps, 2.4 GHz 300Mbps or Quality of
Service operation in an access point network.
The wireless adapter must match the wireless mode of
the access point it associates to.
Wireless Mode when Starting
Specifies 5 GHz 54 Mbps, 5 GHz 108 Mbps, or 2.4 GHz
an
Ad Hoc Network
54/11 Mbps to start an
ad hoc
network if no matching