2. When the indicator blinks, touch the keyless remote to the ENGINE START/STOP button.
NOTE: The indicator will switch from blinking to steady when communication is complete.
3. Start the engine by pressing the ENGINE START/STOP button while applying the brake pedal. You must start
the engine within 10 seconds of touching the remote to the button. If you press the button without applying the
brake pedal, the ACCESSORY power mode will set.
1.
Remove the Exterior Protective Coatings
Carefully remove the Clear Guard protective film, but do not remove the protective plastic on the forward edge of the
rear fenders; it helps protect the front of the fender from rock chip damage. Also, be sure to remove the protective tape
from the front chin spoiler (under the front bumper). See S/B 96-009,
Removal of Protective Coatings During TQI.
Page
3
of
11
