n
Resetting the Engine Oil Life
If you change or replace the vehicle’s engine oil yourself, you must reset
the engine oil life.
1. Set the power mode to ON.
2. Press the right selector wheel until the content is displayed.
3. Roll the right selector wheel until the Maintenance Minder screen is
displayed.
4. Press and hold the right selector wheel for about 10 seconds to enter
the reset mode.
5. Roll the right selector wheel to select the maintenance item to reset.
6. Press the right selector wheel to reset the selected item.
Failure to reset the engine oil life after a maintenance service results in the
system showing incorrect maintenance intervals, which can lead to serious
mechanical problems.
MAINTENANCE
140 |
Engine Coolant
Park the vehicle on level ground. Check the reserve tank and the coolant level
in the radiator. Use Acura Long Life Antifreeze/Coolant Type 2
n
Checking the Reserve Tank
1. Make sure the engine and radiator are cool.
2. Open the hood. (See Opening the
Hood) Check the amount of
coolant in the reserve tank.
3. If the coolant level is below the
MIN mark, add the specified
coolant until it reaches the MAX
mark.
4. Inspect the cooling system for
leaks.
For vehicles used in temperatures
below -31°F (-35°C) , change the coolant from the standard 50:50
antifreeze:water mix to one with added antifreeze. Consult a dealer for
more information.
n
Adding Coolant
1. Make sure the engine and radiator are cool.
2. Turn the radiator cap 1/8 turn counterclockwise and relieve any
pressure in the coolant system.
3. Push down and turn the radiator cap counterclockwise to remove it.
4. The coolant level should be up to the base of the filler neck. Add
coolant if it is low.
5. Put the radiator cap back on, and tighten it fully.
Removing the radiator cap while the engine is hot can cause the coolant
to spray out, seriously scalding you.
Always let the engine and radiator cool down before removing the
radiator cap.
MAINTENANCE
| 141
