AEVU-751-X86 User Manual
3.3.1 Arm Mounting
The AEVU-751-X86 is VESA (Video Electronics Standards Association) compliant and
can be mounted on an arm with a 75 mm interface pad. To mount the AEVU-751-X86 on
an arm, please follow the steps below.
Step 1:
The arm is a separately purchased item. Please correctly mount the arm onto
the surface it uses as a base. To do this, refer to the installation documentation
that came with the mounting arm.
NOTE:
When purchasing the arm please ensure that it is VESA compliant and
that the arm has a 75 mm interface pad. If the mounting arm is not VESA
compliant it cannot be used to support the AEVU-751-X86.
Step 2:
Once the mounting arm has been firmly attached to the surface, lift the
AEVU-751-X86 onto the interface pad of the mounting arm.
Step 3:
Align the retention screw holes on the mounting arm interface with those on
theAEVU-751-X86, as shown in
Figure
221H221H
4-15
.
Figure 3-15: Arm Mounting Retention Screw Holes
Step 4:
Secure the AEVU-751-X86 to the interface pad by inserting four retention
screws
through the bottom of the mounting arm interface pad and into the
AEVU-751-X86.
Figure 3-16: Arm Mounting (ARM-11-RS)
Page 16
