6 of 6
BII09104-17 (1805)
© 2019 American Honda Motor Co., Inc. – All Rights Reserved.
ENGINE REMOTE START SYSTEM REGISTRATION
NOTE: The PCM code will be required for this procedure.
1.
Connect the i-HDS to the data link connector.
2.
From the HOME menu, select Immobilizer Set Up
Tool.
3.
From the System Selection Menu, select
ONE-PUSH START, then go to Registration.
4.
From the Registration Menu, select KEYLESS
ACCESS Remotes, then select 2-WAY KEYLESS
SETUP. Change the setting to 2-WAY KEYLESS
mode, and follow the i-HDS prompts.
5.
Go back to the KEYLESS ACCESS Remotes
Registration Menu, select Add a KEYLESS
ACCESS Remote, and follow the instructions on the
i-HDS screen. Do not bring the remote starter
remote into the vehicle until the i-HDS asks for the
new remote.
6.
Repeat step 4 for the second remote starter remote.
7.
After registration, verify all remote-related systems
work normally with all remotes.
REMOTE ENGINE START
1.
Press LOCK, then press and hold ENGINE. The
amber LED blinks, and the green LED stays on for
1 second when the engine starts. You can repeat
this once at any time within 10 minutes of the initial
remote start for a 10-minute extension.
2.
While the remote engine start is on, the following
happens:
• The climate control system can warm or cool the
interior, depending on the ambient temperature.
• The security system remains on.
• Exterior lights and accessories remain off.
3.
To start driving after you enter the vehicle, press the
brake pedal and press ENGINE/START/STOP.
STOPPING THE ENGINE
Press and hold ENGINE. The red LED stays on for
1 second.
NOTE: The engine will stop if it has been running for more
than 10 minutes or any door is opened without using the
remote or keyless access.
For additional technical information, refer to the vehicle
owner’s manual.
