Acura 1997 NSX, Онлайн руководство пользователя

Страница: 26 / 275

Child Safety
4. Allow the belt to slowly feed back
into the retractor. You should hear
a clicking noise that indicates the
locking mechanism has engaged.
5. After the belt has retracted fully,
pull up on the shoulder portion to
remove any slack.
6. Push and pull on the child seat to
verify that it is held firmly in place.
If not, unlatch the seat belt, allow
it to retract fully, and repeat these
steps.
To unlatch the seat belt, push the
red PRESS button on the buckle.
Guide the belt across to the door
pillar. If the belt doesn't retract
easily, pull it out and check for twists
or kinks.
Using Child Restraints with
Tethers
Your Acura is equipped with an
attachment point for a child restraint
system that uses a top tether. The
tether attachment point is located on
the panel behind the passenger's
seat-back.
1. Adjust the passenger's seat fully
forward to make room behind the
seat-back.
2. Using the dimensions shown,
measure and mark the location of
the attachment point on the
interior panel.
3. Use a razor blade or sharp knife to
carefully cut a 2.5 cm (1 in)
diameter circle at the point you
marked. Cut through one layer at
a time. You will need to remove
two layers to reach the tether
attachment.
4. Install the tether hardware that
came with the child seat.
Tighten the bolt to:
16 Ibf.ft (2.2 kgf.m, 22 N.m)
Driver and Passenger Safety
4 in (10 cm) 1 in (2.5 cm)
9.7 in
(24.6 cm)