6 of 7
BII 24550 (0209)
© 2002 American Honda Motor Co., Inc - All Rights Reserved.
19. Attach one gray cushion tape to the rear of the CD
changer leaving half of the cushion tape extended
past the CD changer. Using scissors, cut the
cushion tape at the end of the CD changer. Fold the
ends down around the edges of the CD changer.
20. Attach the other gray cushion tape to the CD
changer overlapping the other cushion tape. Fold
the cushion tape around the CD changer bracket.
21. Position the CD changer on the base brackets, and
tighten the four 6 x 12 mm flange bolts you
installed in step 14.
22. Install the four flange nuts on the ends of the studs
that extend from the base brackets, and tighten
them securely.
23. Tighten the four 6 x 12 mm flange bolts you
removed in step 14.
24. Connect the BUS cable connector to the CD
changer connector.
25. Plug the BUS cable connector, the vehicle harness
connector, and the antenna lead into the rear of the
audio unit.
26. Check that all wire harnesses are routed properly
and all connectors are plugged in.
27. Connect the negative cable to the battery. Enter the
customer’s radio anti-theft code, and reset the radio
station presets.
28. Check that the radio and the CD changer work
according to the appropriate owner’s manual.
ANTENNA
LEAD
BUS
CABLE
AUDIO
UNIT
SCREW
VEHICLE
HARNESS
BUS CABLE
CD CHANGER
LEFT BASE
BRACKET
RIGHT BASE
BRACKET
FLANGE
NUT
CD CHANGER
GRAY
CUSHION
TAPE
GRAY
CUSHION
TAPE
