2 of 7
BII 24550 (0209)
© 2002 American Honda Motor Co., Inc - All Rights Reserved.
CLIP
CENTER CONSOLE
LOWER COVER
DRIVER’S
SEAT
4.
Remove the screws fastening the audio brackets,
then pull the audio unit out toward you. Unplug the
vehicle connectors and antenna lead from the rear
of the audio unit.
TOOLS AND SUPPLIES REQUIRED
Flat-tip screwdriver
Phillips
screwdriver
Ratchet
8 mm, 10 mm, and 12 mm Sockets
Shop towel
Diagonal cutters
8 mm and 10 mm Combination wrenches
RADIO
PANEL
CLIP
5.
On the driver’s side of the vehicle, gently pull the
center console lower cover out toward you to
release the clips and remove the center console
lower cover. Take care not to damage the clips.
SCREW
RADIO
BRACKET
ANTENNA
LEAD
VEHICLE
HARNESS
INSTALLATION
Customer Information:
The information in this
installation instruction is intended for use only by
skilled technicians who have the proper tools,
equipment, and training to correctly and safely add
equipment to your vehicle. These procedures should
not be attempted by “do-it-yourselfers.”
1.
Make sure you have the anti-theft code for the radio,
then write down the frequencies for the preset
buttons.
2.
Disconnect the negative cable from the battery.
3.
Using a flat-tip screwdriver wrapped with a shop
towel, pry up on the clips and pull the radio panel
out toward you. Unplug the connectors and remove
the radio panel.
