4 of 4
BII 26193 (0309)
© 2003 American Honda Motor Co., Inc - All Rights Reserved.
13. Plug the antenna lead and the vehicle harness
connectors into the rear of the radio and the
hazard switch. Slide the center panel into the
radio opening, and secure it with two bolts. Using a
10 mm wrench, tighten the bolts securely.
•
Without CD Changer:
RADIO
ANTENNA
LEAD
CASSETTE PLAYER
VEHICLE
20-PIN
CONNECTOR
CD CHANGER
BUS CABLE
(when the CD
changer is installed)
VEHICLE HARNESS
CONNECTOR
BOLT
CENTER PANEL
ANTENNA LEAD
•
With CD Changer: Plug the connector of the CD
changer BUS cable into the cassette player.
CONNECTOR
14. Reconnect the negative cable to the battery.
15. Check the operation of the cassette player
according to the Owner’s Manual supplied.
16. Enter the radio anti-theft code, and reset the
customer’s radio station presets.
17. Reset the clock.
18. Put the cassette player Owner’s Manual and the
pocket and screws (removed in step 8) into the
glove box.
NOTE: Whenever the battery is disconnected, the
driver’s window AUTO function is disabled.
19. Start the engine. Push down on the driver’s
window switch until the window is fully open.
20. Pull up on the driver’s window switch to close the
window completely, then hold the switch for a
second or two more.
21. Test the window AUTO function.
22. Do the ECM/PCM idle learn procedure.
•
Make sure all electrical items are turned off.
•
Start the engine. Hold the engine speed at
3,000 rpm with no load (in Park or Neutral) until
the radiator fan comes on.
•
Let the engine idle for about 5 minutes with the
throttle fully closed and with all electrical items
off.
NOTE: If the radiator fan comes on during this
step, the time when it is operaing must not be
included in the 5 minutes.
