Acucraft circular 4, Руководство оператора

Страница: 22 / 46

22
Gas Valve & Ignition Module
SUPPLEMENTAL MATERIAL
Thermostat Compatibility:
Compatible with any Honeywell 24V thermostat and
with competitive 24V thermostats that are powered
indepen- dently of the module.
Transformer Sizing:
Add current ratings of Y8610, vent damper, and any
other control system components. Multiply this total
by 24V to determine the transformer VA requirement.
Mounting:
Mounts in any position except with terminals up.
Recom- mended mounting position is with terminals
down to provide maximum protection from dripping
water or dust accumula- tion. Refer to Fig. 14 on page
12.
Fasten with No. 6-32 machine screws or No. 8 sheet
metal screws or 8-18 x 5/8 pan head tapping screws
of appropriate length.
Table 2: Dual Valve Combustion Gas Controls Speci -
fications
Mounting:
Can be mounted from 0 to 90 degrees, in any direc -
tion, from the gas control upright position
Pressure Rating: 1/2 psig (3.45 kPa) inlet pressure
Terminals:
1/4 in. male quick-connect terminals
Wiring Connections:
— Between the module and gas control: 30 in. (762
mm)
wiring harness with 1/4 in. quick-connect terminals.
— Between the module and the igniter-sensor: 30 in.
(762 mm) ignition cable with stud terminal and 1/4 in.
quick-connect terminal.
Terminals:
1/4 in. male quick-connects. S8610U has Molex plug
for connection to a vent damper harness. Once the
S8610U has powered a vent damper, the module
works only if the vent damper is connected.
DRAFT