ACU-RITE 02084, Инструкция по эксплуатации

Страница: 2 / 8

SETUP
Install or Replace Battery
1. Flip open the battery compartment.
2. Connect 1 x 9V battery to the battery connector and insert into the
battery compartment, as shown.
3. Close the battery compartment.
1
Open Battery
Compartment
Connect & Insert Battery
1 x 9V Battery
2
9V
Select Temperature Units, Backlight & Laser Settings
Once the unit is powered on, you may select temperature units, backlight and
laser settings.
To select between degrees Fahrenheit (°F) or Celsius (°C) temperature units,
press and release the “°C/°F” button.
To enable or disable the backlight, press and release the " " button.
To enable or disable the built-in laser sight, press and release the " " button.
PLEASE DISPOSE OF OLD OR DEFECTIVE BATTERIES IN AN ENVIRONMENTALLY SAFE
WAY AND IN ACCORDANCE WITH YOUR LOCAL LAWS AND REGULATIONS.
BATTERY SAFETY: Clean the battery contacts and also those of the device prior to battery installation. Remove batteries from equipment which is not to
be used for an extended period of time. Follow the polarity (+/-) diagram in the battery compartment. Promptly remove dead batteries from the device. Dispose of
used batteries properly. Only batteries of the same or equivalent type as recommended are to be used. DO NOT incinerate used batteries. DO NOT dispose of batteries
in fire, as batteries may explode or leak. DO NOT mix old and new batteries or types of batteries (alkaline/standard). DO NOT use rechargeable batteries. DO NOT
recharge non-rechargeable batteries. DO NOT short-circuit the supply terminals.
2