Installing Batteries - Wireless Sensor
Installing Batteries - Display Console
SETUP
SETUP
3
2
Remove the battery
compartment cover.
Install 2 fresh “AA”
batteries as shown here.
BATTERIES MUST BE
INSTALLED FOR THE SENSOR
TO OPERATE
Remove the battery
compartment cover.
Install 3 fresh “AA”
batteries as shown
here.
Display Console : Basic Setup
In North America, the National Institute of Standards and Technologies
operates an atomic clock in Colorado which transmits the time codes via the
radio station WWVB. The Acurite clock you have purchased includes a built-in
receiver which picks up the signal from the WWVB station. For the best
possible reception, place the display unit with the back side facing Colorado.
Synchronization with the WWVB atomic clock signal happens at night when
there is less interference.
About the Self Setting Atomic Clock
Battery Choice & Temperature Range
Extended periods of cold temperatures ( below -4ºF / -20ºC ) can cause alkaline
batteries to function improperly. This will cause the outdoor wireless sensor to
stop transmitting temperature readings. Use lithium batteries in these low
temperature conditions to ensure continued operation for wireless sensors
placed outdoors.
40
Press and hold the “SET” button to enter into set mode. The time zone (next to
the clock display) will begin blinking.
To adjust the currently selected (flashing) preference item, press and release
the “ ” or “ ” buttons.
To save your adjustments, press and release the “SET” button again to move
on to adjusting the next preference. The preference set order is as follows:
TIME ZONE ( PST MST CST EST AST HAST AKST)
DST (Daylight Saving Time ON or OFF)
CLOCK HOUR
CLOCK MINUTE
CALENDAR MONTH
CALENDAR DATE
CALENDAR YEAR
LANGUAGE SELECTION (ENGLISH, FRENCH, OR SPANISH)
You will automatically exit SET MODE if no entries are changed for 30 seconds.
You may enter basic setup mode again at any time by pressing and releasing
the “SET” button.
SELECT ºF OR ºC TEMPERATURE UNITS
This forecaster is capable of displaying the temperature in either Fahrenheit
or Celsius temperatre scales. Press and release the “ºF/ºC” button to change
the scale selection.
A/B/C Wireless Selection
To allow for more than one weather station and wireless sensor network to be used in
close proximity, the display unit and the wireless sensor have a small switch labeled “A
B C” within the battery compartments. This switch selects one of 3 wireless modes to
use, and both switchs MUST be set in matching positions (either A, B, or C) fore wireless
communication to take place successfully.